Hello, I make jewelry and it has a thin layer of gold plating. As a result, the jewelry discolors back to silver quite quickly. I would like to prevent this with Protecta Clear. Is this skin-friendly and does it keep the color looking good for longer? If so, how long does it stay looking good on average and how many layers do I need to spray? I would prefer to order the spray, but a colleague of yours mentioned that this might cause difficulties with shipping to the Netherlands. Do you also ship to the Netherlands and what are the costs for that? She also suggested that I should order a Preval spray system and Preval power unit; however, I cannot find this anywhere on the website. Where can I find this? And how many ml would you recommend for me to buy? I look forward to hearing from you.…

Just had my delivery but 505 prep fluid is missing from the large CT-7571-T kit, also the sealer doesn’t state that it’s SATIN anywhere on the label

Want to clean, accelerate and Matt seal before resin path installed, any experience in the group

can i travel on a comercial flight to the Canary islands with this product in my suitcase. i must of sent 4 emails to everbrite asking this question and had no replies. thank you

Hi,

I have been heat treating some stainless steel, with great results. I would like to lacquer the piece to protect the vibrant colours but when I use ProtectaClear it seems to dull down the colours, especially the blues and purples. Can you recommend another finish?

Thanks,

Sam

Would this product work well on brass door push plates in order to stop having to polish them with brasso polish each week?

I would just like to say that this product is absolutely amazing. It is so easy to apply and the results are spot on. I use it on items that we gold plate. I recommend not using any Acetone to clean items as this causes issues that I quickly worked out. I tend to use smaller pieces of the lint free cloths also purchased and if lacquering larger items I use a few small pieces and have outstanding results. I just use the prep 1-4 mix and let dry and then straight on with the lacquer. I've never needed to use anything else at all to prep anything. This is on newly plated items that are not touched other than with nitrile gloves on.

Hello!

I am using Protectaclear on mild steel and copper parts. The first time I used it I good a good result. Since then the finish has not come out right. Please see attached pictures below , these taken after about 18 hours drying.

I have attempted to coat these particular parts twice now, and both times I have had a similar result. I had to spend nearly a day removing the finish with Acetone after the first failed attempt and now on the second attempt I have the same poor result! All parts are cleaned carefully with acetone and allowed to fully dry before coating. Indoor environment at around 15C, and I am using brand new lint free cloths each time. Application by wiping on and pot well shaken before use. It goes on fine initially and looks to be self levelling OK as expected, but then seems t…

Can protecaclear used on 304 stainless steel to prevent corrosion in coastal areas ,ie a harbour,if so would it need re treating